! Pinging over pseudowire using EVC on PEs with dot1q encapsulation ! ME3600 interface GigabitEthernet0/1 description 1941-1-Gi0/0 switchport trunk allowed vlan none switchport mode trunk no cdp enable service instance 11 ethernet encapsulation dot1q 11 bridge-domain 11 interface GigabitEthernet0/2 description 1941-1-Gi0/1 switchport trunk allowed vlan none switchport mode trunk no cdp enable service instance 11 ethernet encapsulation dot1q 11 bridge-domain 12 interface GigabitEthernet0/3 description ME3800-Gi0/1 switchport trunk allowed vlan none switchport mode trunk no cdp enable service instance 11 ethernet encapsulation dot1q 11 bridge-domain 11 interface GigabitEthernet0/4 description ASR1K1-Gi0/0/0 switchport trunk allowed vlan none switchport mode trunk no cdp enable service instance 11 ethernet encapsulation dot1q 11 bridge-domain 12 ! ME3800 interface GigabitEthernet0/1 description ME3600-Gi0/3 switchport trunk allowed vlan none switchport mode trunk no cdp enable service instance 11 ethernet encapsulation dot1q 11 xconnect 10.0.0.2 123 encapsulation mpls ! ASR1K1 interface GigabitEthernet0/0/0 description ME3600-Gi0/4 no ip address no ip unreachables no ip proxy-arp negotiation auto service instance 11 ethernet encapsulation dot1q 11 xconnect 10.0.0.1 123 encapsulation mpls ! 1941 interface GigabitEthernet0/0.11 encapsulation dot1Q 11 ip vrf forwarding vrf1 ip address 192.168.0.1 255.255.255.248 no ip redirects no ip unreachables no ip proxy-arp no keepalive no cdp enable interface GigabitEthernet0/1.11 encapsulation dot1Q 11 ip vrf forwarding vrf2 ip address 192.168.0.2 255.255.255.248 no ip redirects no ip unreachables no ip proxy-arp no keepalive no cdp enable 1941-1#ping vrf vrf1 192.168.0.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.0.2, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms ME3800#show mpls l2transport vc 123 detail Local interface: Gi0/1 up, line protocol up, Eth VLAN 11 up Interworking type is Ethernet Destination address: 10.0.0.2, VC ID: 123, VC status: up Output interface: Gi0/2, imposed label stack {20} Preferred path: not configured Default path: active Next hop: 10.0.20.2 Create time: 00:02:33, last status change time: 00:02:33 Last label FSM state change time: 00:02:33 Signaling protocol: LDP, peer 10.0.0.2:0 up Targeted Hello: 10.0.0.1(LDP Id) -> 10.0.0.2, LDP is UP Graceful restart: not configured and not enabled Non stop routing: not configured and not enabled Status TLV support (local/remote) : enabled/supported LDP route watch : enabled Label/status state machine : established, LruRru Last local dataplane status rcvd: No fault Last BFD dataplane status rcvd: Not sent Last BFD peer monitor status rcvd: No fault Last local AC circuit status rcvd: No fault Last local AC circuit status sent: No fault Last local PW i/f circ status rcvd: No fault Last local LDP TLV status sent: No fault Last remote LDP TLV status rcvd: No fault Last remote LDP ADJ status rcvd: No fault MPLS VC labels: local 19, remote 20 Group ID: local 0, remote 0 MTU: local 1500, remote 1500 Remote interface description: ME3600-Gi0/4 Sequencing: receive disabled, send disabled Control Word: On (configured: autosense) Dataplane: SSM segment/switch IDs: 4125/4124 (used), PWID: 2 VC statistics: transit packet totals: receive 2000, send 2000 transit byte totals: receive 288000, send 244000 transit packet drops: receive 0, seq error 0, send 0 ME3800#show mpls l2transport binding 123 Destination Address: 10.0.0.2,VC ID: 123 Local Label: 19 Cbit: 1, VC Type: Ethernet, GroupID: 0 MTU: 1500, Interface Desc: ME3600-Gi0/3 VCCV: CC Type: CW [1], RA [2] CV Type: LSPV [2], BFD/Raw [5] Remote Label: 20 Cbit: 1, VC Type: Ethernet, GroupID: 0 MTU: 1500, Interface Desc: ME3600-Gi0/4 VCCV: CC Type: CW [1], RA [2], TTL [3] CV Type: LSPV [2] ASR1K1#show mpls l2transport vc 123 detail Local interface: Gi0/0/0 up, line protocol up, Eth VLAN 11 up Interworking type is Ethernet Destination address: 10.0.0.1, VC ID: 123, VC status: up Output interface: Gi0/0/1, imposed label stack {19} Preferred path: not configured Default path: active Next hop: 10.0.20.1 Create time: 00:03:26, last status change time: 00:03:11 Last label FSM state change time: 00:03:11 Signaling protocol: LDP, peer 10.0.0.1:0 up Targeted Hello: 10.0.0.2(LDP Id) -> 10.0.0.1, LDP is UP Graceful restart: not configured and not enabled Non stop routing: not configured and not enabled Status TLV support (local/remote) : enabled/supported LDP route watch : enabled Label/status state machine : established, LruRru Last local dataplane status rcvd: No fault Last BFD dataplane status rcvd: Not sent Last BFD peer monitor status rcvd: No fault Last local AC circuit status rcvd: No fault Last local AC circuit status sent: No fault Last local PW i/f circ status rcvd: No fault Last local LDP TLV status sent: No fault Last remote LDP TLV status rcvd: No fault Last remote LDP ADJ status rcvd: No fault MPLS VC labels: local 20, remote 19 Group ID: local 0, remote 0 MTU: local 1500, remote 1500 Remote interface description: ME3600-Gi0/3 Sequencing: receive disabled, send disabled Control Word: On (configured: autosense) SSO Descriptor: 10.0.0.1/123, local label: 20 Dataplane: SSM segment/switch IDs: 4124/4123 (used), PWID: 1 VC statistics: transit packet totals: receive 2000, send 2000 transit byte totals: receive 236000, send 280000 transit packet drops: receive 0, seq error 0, send 0 ASR1K1#show mpls l2transport binding 123 Destination Address: 10.0.0.1,VC ID: 123 Local Label: 20 Cbit: 1, VC Type: Ethernet, GroupID: 0 MTU: 1500, Interface Desc: ME3600-Gi0/4 VCCV: CC Type: CW [1], RA [2], TTL [3] CV Type: LSPV [2] Remote Label: 19 Cbit: 1, VC Type: Ethernet, GroupID: 0 MTU: 1500, Interface Desc: ME3600-Gi0/3 VCCV: CC Type: CW [1], RA [2] CV Type: LSPV [2], BFD/Raw [5]