#############################################
# ME1.                                      #
#############################################

interface GigabitEthernet0/3/22
 trap-threshold crc-error high-threshold 10 low-threshold 1 interval-second 1
 mtu 1786
 description Test
 undo shutdown
 set flow-stat interval 30
 mpls l2vc 10.0.34.250 989903001
 mpls l2vc 10.0.34.250 989913001 secondary
 mpls l2vpn redundancy master
 undo lldp enable
 undo dcn


# CX600 can only have one MA configured against an interface that is the AC of
# of a port based pseudowire. With backup pseudowires, when the primary
# pseudowire is up only the primary pseudowire responds to the MEG ID
# configured in the single MA. The secondary pseudowire will not respond to 
# this MEG ID. When the primary pseudowire is down the same MEG ID will respond
# over the secondary pseudowire. This means that only the active pseudowire
# can be monitored at any time:

cfm md test format no-md-name level 2
 # This ma name must match the MAID on the ASR9904 PE:
 ma 40 format icc-based ATest98053001
  map mpls l2vc 989903001 raw
  # 1 minute - This must batch on the ASR9904
  ccm-interval 60000
  # inwards is Up MEP / outward is Down MEP:
  mep mep-id 3 interface GigabitEthernet0/3/22 inward
  mep ccm-send mep-id 3 enable
  remote-mep mep-id 1
  remote-mep ccm-receive mep-id 1 enable
  test-id 98053001 mep 3 remote-mep 1
  # 10 seconds interval - only uncomment if you want continuous tests to run from the CX600 PE
  # delay-measure two-way continual send test-id 98053001 interval 10000
  delay-measure two-way receive test-id 98053001

# display cfm remote-mep md test
# display cfm mep md test
#
# Test with (uses LBM/LRM messages):
# ping mac-8021ag mep mep-id 3 md test ma 40 remote-mep mep-id 1
# ping mac-8021ag mep mep-id 3 md test ma 40 mac 6c8b-d33f-e295